STEP 1: REFINE YOUR CUTICLES 

Gently guide back cuticles using the provided tool to create a clean, defined nail bed.

STEP 2: BUFF NAIL SURFACES 
Lightly buff each natural nail surface with the file. This subtle texturizing is key for optimal adhesion.

STEP 3: CLEANSE & PRIME
Thoroughly cleanse your nails with the alcohol wipe, removing all natural oils. Allow to air dry completely.

For lasting results, avoid touching your natural nail surfaces after this step. This ensures the adhesive can bond perfectly without interference from oils.

STEP 1: SELECT & SECURE ADHESIVE TAB
After nail prep, choose an adhesive tab closest to your nail size. Peel, apply smoothly to your natural nail, and press firmly for full contact and a secure base.

STEP 2: ATTACH PRESS-ON
Remove the protective film. Align your press-on near the cuticle (at a 45-degree angle for a natural fit). Press down firmly for 10-15 seconds to bond. Repeat for all nails.

STEP 3: THE FINISHING TOUCH
For a polished look, consider applying cuticle oil around your cuticles. This hydrates and beautifully frames your new set.

For best adhesion, avoid water for the first 2-3 hours to allow the adhesive to fully set.

STEP 1: APPLY THE GLUE
After preparing your nails, put a small drop of nail glue onto your natural nail. You can also put a thin layer of glue on the back of the press-on nail instead.

STEP 2: ATTACH PRESS-ON
Remove the protective film. Align your press-on near the cuticle (at a 45-degree angle for a natural fit). Press down firmly for 10-15 seconds to bond. Repeat for all nails.

STEP 3: THE FINISHING TOUCH
For a polished look, consider applying cuticle oil around your cuticles. This hydrates and beautifully frames your new set.

For best adhesion, avoid water for the first 2-3 hours to allow the adhesive to fully set.

STEP 1: PREP A WARM SOAK
Soak fingertips in warm water with a little soap and oil for 10-15 minutes, or until press-ons loosen.

STEP 2: GENTLY LIFT NAILS
Use the cuticle tool to carefully lift press-on edges. If resistant, re-soak - never force.

STEP 3: REMOVE ADHESIVE
Gently roll or nudge off any leftover adhesive from natural nails and press-ons with the cuticle tool.

STEP 4: CLEANSE & STORE
Wipe press-on backs with an alcohol pad to remove oils. Air dry, then store in your box for reuse.

TIP 1: CLEANSE AFTER WEAR
Wipe the back of each press-on with an alcohol pad to remove residue and oils. Air dry thoroughly

TIP 2: STORE PROPERLY
Keep your clean, dry press-on in their original box to prevent damage and maintain their pristine condition.

TIP 3: MINIMIZE HARSH CONTACT
Protect your nails from harsh chemicals and abrasive tasks. Consider gloves for chores to preserve their finish.

TIP 4: REFRESH FOR REUSE
Gently buff or scrape away any stubborn old adhesive from the back of the press-on for a smooth reapplication.